Electronic SystemS TF-108 Manual del operador descargar pdf (Pagina 11)

TF-DSQ Probe Calibration and Deskew Fixture

TF-DSQ-OM-E RevC

TF-DSQ Oscilloscope Connection

The TF-DSQ fixture is connected to either an unused oscilloscope channel or the external AUX IN

input, if one exists. In other words, any oscilloscope channel or oscilloscope input with a ProLink

or ProBus connector.

Scope Auxiliary Input with ProLink and

BMA Connector

Connection of the TF-DSQ Fixture to the

Oscilloscope Input

We recommend connecting to the AUX IN input, or to an unused oscilloscope channel in the

case of a Serial Data Analyzer with the "A" model suffix (these oscilloscopes replace the external

trigger input with a clock recovery module).

Note: Your kit contains both ProBus and ProLink extenders, so regardless of the AUX IN input

used for your signal (BNC or BMA), your specific connection need is covered.

The TF-DSQ fixture is called out as the probe calibration source on the probe calibration menu.

Seeing this option on the menu verifies proper operation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

Sin comentarios

Electronic SystemS TF-108 Manual del operador Pagina 11